Home / making decking steps
Exterior wooden decks are built in a variety of styles. Most decks require only one or two steps to lead from the ground floor level of a home to the yard below. Making the steps too steep can
Building a Deck 7 Deck Building Tips from the Pros. Techniques for deck building, framing a deck, building stairs and railings and adding deck trim. Deck Building Step 5: Strhten a bowed deck board. Set and nail the boards. Set the board, bow in, and nail one end. Work toward the other end, nailing as you go.
Continue screwing down the decking making sure to allow for a 1/4" gap between each plank. Attach several rows and stagger the cut seams for structural and aesthetic value Image 2 . Step 10 How to Add Stairs to Your Deck. Building deck stairs will provide ready access to the yard and add value to your home.
If you own your own home, I bet you have also looked up how to build a deck step by step with pictures. Last spring, I decided it was time to figure it out. So I set about learning how to build a deck step by step with my friend Dave. Make no mistake, Dave was the brains of the operation.
Exterior steps should be built using non-corrosive deck screws. Making Wooden Steps. The Concept. Three stringers, risers and treads. Stringers and Mounting. Stringers mounted to a deck rim joist Popular Mechanics diagram Stringers are built out of 2" x 12" lumber for strength. They are designed by dividing the total height of the stairs by
If you use the deck itself as the top riser as with this deck, subtract one step. This deck will have treads made of 5/4-inch x 6-inch decking planks two for each step making the run for each step the distance front-to-back about 11 inches.
A decks stairway should be carefully planned so that all the stair rises the vertical height of the steps and all the tread depths the horizontal length of the step runs are equal. If the bottom or top step is noticeably different in height or length from the other stairs, it will be a tripping hazard.
This will allow the first step to be the original 7" rise height once the 1 ¼" decking material is placed on top. The 9.5" for each run will allow 1 ½" of tread to hang over each step making for a more comfortable "nose" on each step.
Leave less than a 6 gap between steps and this lower railing. Cut 2x2 boards to create balusters that extend from top railing to lower railing Image 1 . Attach them to railings using 3 deck screws, making sure they are plumb and that the gap between them is no larger than 6.
This will give you the number of steps you will need to make. Adjust the height until the height and steps balance out since you can't have a half or quarter of a step . Take the number of steps and multiply that by 10.5 inches 266.7 mm . That gives you the length of stair stringer necessary. Take that length and project it out from the deck.